The best 3 Pin Interface for Guzzidiag, TuneECU, DucatiDiag, JPDIAG and similar softwares, just got even better. Now a 1 piece interface with 3 pin FAL connection & even more added voltage protection. No more damage to cables or your bike if you accidentally connect clips to your battery the wrong way around! This kit is for bikes using the 3 pin connector. Always check your model with software compatibility & which one you need. If you have the 4 pin ECU connector then you will require a different interface and adaptor – please CLICK HERE Our lead is guaranteed to connect. It uses a genuine FTDi chipset and is UK manufactured. All components are sourced either directly from manufacturers or authorised distributors. GuzziDiag and JPDiag (formerly DucatiDiag) are freeware/shareware for Moto Guzzi and Ducati Motorbikes. Also for some Aprilia models & others using a similar ECU set up. Allowing diagnostics and ECU remapping. You can get further information from their relative websites. TuneECU software now also covers some Aprilia, Ducati, Moto Guzzi, Moto Morini & Gilera models. Please see all relative websites for precise models covered. We include FULL instructions on installing and full back up to ensure that you get this item up and running. IMPORTANT: A small amount of Aprilia Tuono bikes use a 3 pin connection with a Siemens ECU. This is not suitable for this adaptor. Do please check. If your 3 pin diagnostic connector has 3 wires going to it, then it will likely have a Siemens ECU and won’t be compatible. Cable Bundle options? If using with Guzzidiag then you would usually only need the USB-A cable. This is the regular USB plug type for most desktops and laptops. Though some late notebooks now also have USB-C usb sockets. If using with TuneECU Android then you will usually need either a USB-Micro or USB-C adaptor, depending on your phone/tablet. If you are not sure then just contact us telling us what device you’re using and we can advise. You can also buy extra USB cables for the KL-1 family of interfaces here, should you require more than one connection type. Key features: * Fully supports single & dual line K-lines with auto switching * Quality made circuit using FTDi chipset * Virtual Com Port via USB connection * Read and Reset Fault Codes * Works with numerous third party softwares * Cable length 1.0m * DC Power socket allows option of connecting your own 12v DC power supply Compatibility: Works with GuzziDiag, JPDiag, DucatiDiag, TuneECU and other third party softwares. Bike models must be as specified by relevant software. Link to GuzziDiag website – click here Link to JPDiag website – click here Link to TuneECU website – click here Also MultiECUScan compatible for older Fiat Group cars using the 3 pin FAL connection (Fiat/Alfa Romeo/Lancia) Contents: 1 x KL-1TALIA Interface with 3 pin FAL plug. 1 x USB cable (A, Micro or C). 1 x DC power plug with battery clips 1 x Installation instructions.
